To be noted, there will be a few options such as a connection test, and an internet test.

Device will take a reboot and before that, it is gonna take some time to complete the connection process.Īfter the reboot is done, you will see your IP is visible on the top right corner of your screen.

Click on your Wi-Fi and type the password down.

There will be shown a list of your available Wi-Fi signals.

After that you have to click on Connect to Wi-Fi.

After that go to Advanced System Configuration and then network and Wi-Fi setup.

Make sure you have turned on the mobile interface.

Then go to Web & Mobile interface section.

Scroll down to the bottom until you find Pentair User Portal.

First, in the interface of your Pentair intellicenter, go to Settings.

So, we gotta make you sure that, This process will be going on the screen. They get puzzled as the interface is a complex in the device. Verify the wiring to the protocol adapter and IntelliTouch Load Center.So, many users don’t find the Wi-Fi connection interface. You canunplug and plug back in the wireless router to reset it.ģ. Cycle the power to both of these devices.You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. These two devices should be located near one another. Verify the wireless router Power LEDin on.

Locate your ScreenLogic2 Protocol Adapter and wireless router. If step 1 does not fix this issue, go to step 2.Ģ. The Tablet reboot process will take approximately 20 seconds.ī. Wireless Tablet – Press the Suspend button located on the left-side of the Tablet for approximately 4seconds. In most cases, theeasiest way to re-establish a connection is to perform a cold boot of the ScreenLogic2 device:Ī. Make sure your wireless ScreenLogic2 device is connected to your wireless router. If ScreenLogic2has been previously working without a problem, try the following steps to resolve the problem:ġ. If the Configuration program displays “Looking for controller,” for longer then 60 seconds when you startIntelliTouch ScreenLogic2, this may indicate a communication problem somewhere in the system. Why does the Configuration program say “Looking for Controller”? 1.1 (which will then break all your other network devices connections) however then once the ScreenLogic was connected you could then change the gateway address in ScreenLogic settings back to use the homes gateway of 192.168.0.1. 0.1 so the fix was to go into the home router settings and change it to use 192.186.

There was a similar post about the ScreenLogic not being able to connect through the OPs home network, and it was due to the ScreenLogic having a default gateway (network address) setting of 192.168.1.1 For some reason the ScreenLogic reset itself to its default settings.

Pentair screenlogic2 interface download